motogadget m.unit basic


The m.unit basic is the digital control unit for your motorcycle – the heart of the entire on-board electrical system. It controls all necessary components on the vehicle while also performing fuse functions.

In stock (can be backordered)

SKU:4002035 Category:


With motogadget m.unit basic, there are considerably fewer relays and individual components in the wiring harness and the motorcycle can be rewired with less effort in a very short amount of time.

When using the m.button, all switch connections are reduced to one single cable. You can learn more about m.button here.

  • Complete digital control using buttons possible with 4 or 5-button operation. Latching switches are also possible
  • Complete replacement for the fuse box. 10 independent circuits are digitally monitored and switched off if there are faults. After the fault is rectified, the safety function is automatically reset
  • Integrated alarm system that can be installed in any position
  • Integrated, digital flasher relay that is load-independent; automatic switch-off optional and can be set; m.wave mode can be selected
  • Integrated hazard warning light
  • Turn signal can optionally be set as a positioning light
  • Integrated parking light and headlight flashing
  • Lo-beam and Hi-beam (up to 200 W switched capacity) can be controlled using only one button
  • Integrated, digital brake light modulator; flashing mode can be programmed
  • Acceleration-controlled emergency brake light (automatic warning signal)
  • Integrated starter relay for the starter system with solenoid (up to 30 A switched capacity)
  • Intelligent and configurable management/switch-off of power consuming devices so that the maximum starting energy from the battery can be used when starting the motorcycle
  • Integrated, digital horn relay
  • Two configurable additional outputs AUX1 and AUX2
  • Diagnostics function for assigning inputs, outputs, the circuit switching status, short circuit diagnostics etc.
  • Calibration and current measurement enable faults to be detected on all lamps

Length / Width / Height            90 x 53 x 30 mm, bolt distance 74 mm
Weight                                     approx. 180 g
Operating voltage                    6 V – 20 V

Inputs                                      1 x input (+12 V switched) for ignition lock or m.lock

11 x control input (minus/switched to ground) for:
Left turn signal
Right turn signal
Lo/Hi beam
Kill switch
Stand switch
LIN bus

Outputs                                   10 x Outputs (+12V) for:

Left turn signal
Right turn signal

Parts Delivered

motogadget m.unit basic
50 cm connecting cable for battery positive terminal with 10 mm² cross section
2 cable eyes
1 x M5 stainless steel bolt
2 x M5 stainless steel bolts with nut
Detailed installation and operating instructions